If you are visual learner, here is a video. Below are written instructions.
1. Prep Your Surface
Make sure your project surface is clean and dry. Any dust or oils will prevent your decal from sticking well.
2. Remove the Transfer Tape The name decal has a clear liner of transfer tape over the top so that you can apply the sticky side of the vinyl to the box. Peel away the clear liner at a 45-degree angle, making sure the vinyl name is adhering to the transfer tape. If the vinyl does not separate from the liner, simply burnish/rub the transfer tape onto the vinyl using a credit card or craft stick and peel away again.
3. Place the Decal
Gently place the transfer tape with vinyl name onto your surface how you would like it to appear. Do not rub it on yet. Check that you have it centered. If you aren’t satisfied, you can gently pick it up and re-center.
4. Apply the Decal
Using a credit card, burnish/rub the transfer tape onto the surface, starting in the center and moving out toward the edges. Make sure you go over the whole thing several times. This step will ensure that your vinyl stays put.
5. Remove the Transfer Tape
Peel the transfer tape away from the vinyl at a 45-degree angle. If the vinyl sticks to the transfer tape and not the box, simply place the transfer tape back over the vinyl and burnish/rub the vinyl onto the surface again. Then continue to peel the transfer tape away from the vinyl. Once removed, the transfer tape has done its job and can be discarded.
Comments